Setting the Picker Identification on the control board

Each Picker of a Cell must have a unique identifier to communicate properly. To set this identifier follow the steps below:
  1. Get the identifier (1-8) needed for the Picker, using the layout / overview found in the electrical diagrams.
  2. Make sure the control board is disconnected from the power supply.
  3. Find the potentiometer marked “Picker ID” on the control board and gently turn it fully clockwise.
  4. Power the microcontroller directly using a generic 5VDC power supply and USB type C cable.
  5. Slowly turn the potentiometer fully counterclockwise and wait 3 seconds for the LED to stop blinking.
  6. Very slowly turn the potentiometer clockwise until the number of LED blinks reflect the required identifier number.
  7. Disconnect the power.
  8. The identifier has now been set and the control board is ready for use.
  9. Contact customerservices@houdijk.com if further assistance is required.